AEG ID ARE DT1 LF, Руководство по установке

Страница: 12 / 28

--------------------------------------------------------------------------------12/28--------------------------------------------------------------------------------
You have to unplug the device and plug the device in again to use the new setting. Don’t forget to use the
command VSAVE to save the new setting.
If the reader is in HID mode, you can not send any commands to the device. Because of that you have to
use the Set-Up card – interface to switch the reader back from HID mode to serial interface mode.
1. Plug out the reader
2. Place card no reader
3. Plug in reader into USB-port
4. Wait for the beep tone from reader
5. Plug out reader
6. Remove card from reader
7. Plug in reader into USB port
8. Reader starts using the serial interface
The Set-Up card – interfeace is a EM4305 transponder with data content 0x31D6B82E on page 3,
0x0006008F on page 4 and the password 0x25F8AB6D.