50
GB
Fix the double door holder onto the left side using the
screws (2 pieces). Be careful that the door edge of the
freezer is parallel with the edge of the mantle.
Fit the door of the refrigerator to the double door
holding pin.
Fix the bottom door holder onto the left side using the
screws (2 pieces) and the adjustable foot as well as
screw the 2 pieces screws on the opposite side into the
vacant holes. Be careful that the door edge of the
refrigerator is parallel with the edge of the mantle.
Put over the handle on the opposite side and cover up
the vacant holes with the plastic nails from the bag of
instruction book.
After released the screws the adaptation of the doors
can be adjusted with the horizontal control of central
door holder.
Put the appliance to its place, set it level and connect
to the electricity supply.
In case you do not want to perform the procedures above,
call the nearest brand-mark service. Technicians will
accomplish the refitting expertly for charge.
Electrical connection
This refrigerator is designed to operate on a 230 V
AC (~) 50 Hz supply.
The plug must be put into a socket with protective con-
tact. If there is no such, it is recommended to get an
electrician to fit an earthed socket in compliance with
standards near the refrigerator.
This appliance complies with the following E.E.C.
Directives:
73/23 EEC of 19.02.73 (Low Voltage Directive) and sub-
sequent modifications,
89/336 EEC of 03.05.89 (Electromagnetic
Compatibility Directive) and subsequent modifica-
tions.
96/57 EEC - 96/09/03 (Energy Efficiency Directive) and
its subsequent amendments
