AE Techron DSR 100-15, Инструкция по эксплуатации

Страница: 17 / 68

Running a Test
One or more waveforms and/or controls that have been added to the active test window can be run using the controls located
below the active window.
RUN:
When the Run button is pressed, the active test sequence will be sent to the DSR 100-15, and the system will
begin generating signal starting at the beginning of the test sequence (the waveform or control farthest to the left). The
System Status reporting message will change from 'Idle' to '1 of X,' with X being the total combined number of waveforms
and controls in the test.
An individual segment may be highlighted in the active test window during playback. This occurs when the DSR 100-15
system is currently generating the highlighted segment and the segment is equal to or greater than one second in duration.
Segments shorter than one second are too short to register as being highlighted.
STOP:
When the Stop button is pressed, the DSR 100-15 will stop signal generation, and the test will reset to the start of
the first waveform. The system will report its status as 'Idle.' The system will also report its status as Idle at all times that the
DSR 100-15 is operating normally but a test is not active .
OUTPUT ENABLED/DISABLED: When the Output Enabled button is displayed, the signal defined by the
active test sequence will be generated by the DSR 100-15. When pressed, the Output Enabled button will toggle to the
Output Disabled display , and the test sequence can be run without generating output signal. This can be