Advent Controls A3.02, Руководство пользователя

Страница: 14 / 20

STIME 25. sets the maximum line silence time to 25 seconds
4.8
Adding Auto-dialler SMS Text Numbers
The system can send the input triggered message (2.16) to up to all 511 numbers. To add a text
number the following SMS text message is sent to the system by any master number:
TEXTNUM
<space> number .
e.g.
textnum 07000000000.
4.9
Adding Auto-dialler Call Numbers
The system can call up to all 511 numbers when the input is triggered. To add a call number
the following SMS text message is sent to the system by any master number:
CALLNUM
<space> number .
e.g.
callnum 07000000000.
4.10
Assigning a Number to One Channel Only
Both Call and Text Numbers can be assigned to call/text only when one particular channel is
activated. This is done by appending A or B to the CALLNUM and TEXTNUM commands as fol-
lows:
CALLNUMA 07000000000
calls the number 07000000000 only when channel A is active
TEXTNUMB 07000000000 texts the number 07000000000 only when channel B is active
N.B. Text/Call numbers can also activate the output—there is no need to ADD the number
4.11
International Calling/Texting
The system can call/text international numbers, however the exit code should not be specified
and should be replaced with the ‘+’ symbol e.g:
UK Number 07574163367 should be entered as +447574163367 when outside the UK
4.12
Dial Now
If necessary the system can make a call to a number not stored in it’s memory at any time. This
is achieved using the DIAL command. The call observes the RTIME, CTIME and SILENCE time
settings
DIAL <space>number . make an ad-hoc call to the specified number
e.g.
dial 01517283167.
The call will end when the other party hangs up or the CTIME or SILENCE time limit is reached.
4.13 Input Hold-off Time
Dialling and SMS sending can be delayed from 1 second to up to 250 minutes (over 4 hours) on
either input using the HOLD command. Additionally after sending the SMS message/dialling the
call numbers the system can repeat the action after the delay time again if required.
To set up the hold-ff time the following SMS text is sent to the system;
HOLD 10
10s delay on Input A
HOLDA R10 10s delay on Input A; repeat every 10s