IMPORTANT NOTES ON INSTALLATION & CABLING
Audio signal cables should be kept at least 150mm (6”) away from mains supply cables,
data cables and any other signal or high Voltage cables.
If you must run audio cables past or across such cables, cross them at 90 degrees and
then maintain their distance from each other.
Below is the pin-out detail of the Adpro FastScan, FastVu and FastTrace 15 pin “D”
connector which you may need access to.
PIN FUNCTION
1 AUDIO
OUTPUT
2 AUDIO
INPUT
3
ADPRO TRANSCEIVER DEPENDANT
4
GENERAL ALARM COMMON
5 ACCESS/SECURE
INPUT
6
ADPRO TRANSCEIVER DEPENDANT
7
DATA (D1- FastScan, Data for Others)
8
DATA (D3 – FastScan, Not used for others)
9 AUDIO
COMMON
10 GROUND
11
GENERAL ALARM NORMALLY CLOSED
12
GENERAL ALARM NORMALLY OPEN
13
PTT INPUT (FastScan, Unused for others)
14
DATA (D0 (FastScan, Clock for others)
15
DATA (D2 (FastScan, Strobe for others)
VIEWED FROM FRONT OF ADPRO 15
PIN CONNECTOR
01 02 03 04 05 06 07 08
09 10 11 12 13 14 15
NOTE : THE ADPRO CONNECTOR IS A
CHASSIS MALE (PLUG).
THE CONNECTORS REQUIRED FOR
THE CABLE ARE FEMALES (SOCKETS)
GENERAL NOTES
It is important to follow the wiring instructions carefully!
Observe polarity of each cable connected (where applicable).
Do not connect any power until installation has been completed and checked.
DO NOT use the CW1308 audio cable to run the DC power to the call-point : Run a
separate 2-core cable (See notes below regarding cabling).
DOCUMENT NUMBER AV102SS/OEM/01 REVISION 6.1 1st August 2006 Page
3
of 22
