Advanced Radio Smart Bus, Быстрый старт

Страница: 15 / 24

15
Receiver and Servo Setup
During this stage, we will install the receiver and servos. Note: Before plugging any ser-
vos into the Smart Bus, ensure you have set the regulator to the desired voltage range.
Important: Check the recommended voltage range of your servos, supplying to high of
a voltage to your servos may cause them damage.
During this stage if you have multi-
ple servos on a control surface (Example: 2 servos on an aileron), ensure they are closely
mechanically matched (Little to no Buzz Sound) and both servos are moving in the same
direction before continuing.
Step 1
Ensure that both batteries are plugged into
the Smart Bus. You will need to plug the
smart display is into the switch as it is used
for programming. Ensure your receiver is
plugged into the Smart Bus and your trans-
mitter is on and bound to your receiver. For
more information on this see page 6
Upon start up, you will see the AR logo.
After a few seconds the Smart Screen will
be shown.
Step 2
Press the green Total mA text on the smart
display, this will take you to the main menu.
Step 3
You should now see the Main Menu
Screen. Press the red
SERVO button
on the screen.