5/23/2019
Document Kiosk
Assembly and Operation Instructions
6
Installation
Installing the Kiosk
One of the unique features of the Document Kiosk is that it can be secured to the ground,
the wall or left free standing.
Location
The location for the kiosk should not be in an area where a heating vent is directly
venting on the kiosk and is level. If the kiosk has to be in areas where the floor is not
level the kiosk must be secured to the floor. Failure to secure the kiosk to the floor
presents a danger of the kiosk tipping over.
Floor Mounting
To secure the kiosk to concrete floors, use anchor bolts to bolt the kiosks down. Use four
#10 expandable anchor bolts to secure the kiosk to the floor. For wood floors use four
#10 wood screws 1.5 inches long. Each screw must be able to take a pull force of 300 lbs
and must securely go into the sub-flooring. If there is any question of the stability of the
kiosk move it to a more secure location. Use at least a #10 anchor bolt - nothing smaller.
The holes in the bottom of the kiosk are 0.20 diameters. These are accessed through the
lower section of the kiosk through the air vents on either side. With all mounting options,
please be sure that the washers provided are used.
Wall Mounting
Another option to secure the kiosk is to attach the kiosk to a wall. This is done by
placing the back of the kiosk close to a wall, and attaching the provided wall mounting
ears to the kiosk and wall to secure the kiosk to the wall. Then, using 4 #10 wood screws,
or anchor bolts depending on the material of the wall to ensure the kiosk is secure. See
the table below for more information on dry wall anchors.
