Advanced Energy Thyro-A, Руководство пользователя

Страница: 26 / 38

26
* The table only shows the default configuration of the relay function.
It can be configured by Thyro-Tool family, which message shall be shown by
the relay an which not.
The relay only exists in h RL1, h RLP1, h RL2 or h RLP2 device, not in the h1
types.
DESCRIPTIOn: Thyro-A/Thyro-AX Thyro-S
Thyro-S, Thyro-A and Thyro-AX LEDs RELAy* LEDs RELAy*
Pulse blocking active
(bridge X2.1-X2.2open) Bit0 Pulse Inhibit LED on energised none energised
Mains frequency is 60 hz Bit2 none energised none energised
U limiting active Bit4 Pulse Inhibit LED and Load
Fault LED flash slowly
alternately
energised only with Thyro-A/Thyro-AX ---
I limiting active Bit5 Pulse Inhibit LED and Load
Fault LED flash slowly
alternately
energised only with Thyro-A/Thyro-AX ---
P limiting active Bit6 Pulse Inhibit LED and Load
Fault LED flash slowly
alternately
energised only with Thyro-A/Thyro-AX ---
Relay status (0=relay off/ 1=relay
on) Bit8 none on/off none on/off
Busmodul aktiv (0=no bus
module/1=bus modul active) Bit11 none energised none energised
Thyristor short-circuit (Thyro-S) Bit14 only with Thyro-S --- Test-LED a. Load fault LED
flash slowly
alternately
dropped out
failure in rotating field/
phase (only Thyro-A 2A or 3A/
Thyro-AX 2A or 3A) Bit15 Pulse Inhibit LED and Test
LED flash slowly simulta -
neously
dropped out only with Thyro-A/Thyro-AX ---
TAB. 9 B ERROR fLAGS (STATUS)