ADTRAN SMART/RG SR506n, Руководство пользователя

Страница: 123 / 161

SmartRG Inc., an ADTRAN company. All Rights Reserved. © 2020 123
Field Name Description
networks are configured nearby.
RX Chain Power Save
Select whether to turn on power-save mode. Options are Disable and Enable .
Note: Before setting this parameter, set MIMO-OFDM to Auto .
RX Chain Power Save
Quiet Time Enter the number of minutes that will elapse before quiet time begins. The default is
10
.
RX Chain Power Save PPS Enter the number of seconds for the throughput threshold for when the router engages power
save mode after the quiet time seconds have elapsed. The default is
10
.
54g Rate This option is set to
1 Mbps
and cannot be changed.
Multicast Rate Select the multicast transmission rate for the network according to the speed of your wireless
network. Select from a range of transmission speeds or select Auto to have the gateway auto-
matically use the fastest possible data rate and enable the Auto-Fallback feature. Auto-Fall-
back will negotiate the best possible connection speed between the gateway and a wireless
client.
Options are Auto and 1 - 54 Mbps. The default is Auto .
Basic Rate Select the basic transmission rate ability for the AP. Options are
Default, All, 1 & 2 Mbps
, and
1 & 2 & 5.5 & 6 & 11 & 12 & 24 Mbps
. The default is
Default
.
Fragmentation Threshold Enter the size at which packets will be fragmented into smaller units. The primary con-
sideration for this setting is the size/capability of the circuit. Options are 256 - 2346 bytes.
The default is 2346 bytes.
Note: A high packet error rate is an indication that a slightly increased fragmentation
threshold is needed. When possible, the default value of 2346 bytes should be maintained.
Poor throughput is a likely result of setting this threshold too low.
RTS Threshold The gateway sends Request to Send (RTS) frames to a particular receiving station and nego-
tiates the sending of a data frame. After receiving an RTS, the wireless station responds with a
Clear to Send (CTS) frame to acknowledge the right to begin transmission.
If a packet is smaller than this setting, the WLAN client hardware does not invoke its RTS/CTS
mechanism. Options are 256 - 2347 bytes.
The default value ( 2347 , disabled) should be left in place unless you encounter inconsistent
data flow. In that case, make minor reductions to this value until the issue is resolved.
DTIM Interval Enter the Delivery Traffic Indication Message (DTIM or Beacon rate) countdown variable used
to indicate when the next window is available to client devices for listening to buffered broad-
cast and multicast messages. Options are 1 - 255 . The default is 1 .
Beacon Interval A beacon is a packet of information that is sent from a connected device to all other devices
where it announces its availability and readiness. A beacon interval is the period of time (sent