Adtech NCT-02, Руководство пользователя

Страница: 9 / 29

NCT-04/03/02 Punch CNC System (Commissioning Manual)
stopping dead point;
2.4.1 Machine Main Drive CNC Punch
2.4.1.1 Parameter settings:
P1.085: Punch control: mechanical
P1.078: Punching mode: Continuous - distance
P5.014: Clutch output port
P1.081: Clutch pull-effective level <O>;
2.4.1.2 Shared by Feeding Signal and Stopping Top Dead Center Signal
Feeding signal port: P5.011,
Feeding signal level: P1.080,
0
Note
Single punching stopping top dead center input port: P5.012 must be set to invalid and does not allow pin
assignment, or else the system cannot close the punch;
#
Example
Example: Feeding signal port: IN (14), feeding effective level: 0
Feeding time is: moment that input pin level from 0 to 1;
That is: during input diagnostics, the red - green moment;
Off clutching time is same as above;
)
Scope of Application
This control method can be applied in occasions with relatively low punch frequency;
Advantage: save cost, reduce the risk of damage when a plurality of switches is used;
Disadvantage: Switch mounting location should be considered, the feeding timing and stopping top dead
center position should be accurate;
2.4.1.3 Using Single Punch Stopping Top Dead Center
P5.011, Feeding signal port: P5.011,
Feeding signal level: P1.080,
Single punch stopping top dead center input port: P5.12;
Single punch effective level settings: P1.112;
0
Note:
In this mode, you need to set “P5.013 Nibbling stopping top dead center input port” to invalid;
#
Example
Example: P5.011: IN (14) P1.080: 0
P5.12: IN (15) P1.112: 0
Feeding time is: jump of pin 14 level from 0 to 1;
That is: during input diagnostics, the red - green moment;