Ð 25 Ð
SECURITY CODES
General
Information
As an additional safety feature, other users who do not have a need to know your code can be
assigned different security codes. These secondary users are identified by "user numbers,"
which are selected when assigning a user's security code. You can assign up 14 additional user
codes (user numbers 03-16), including the babysitter and duress codes. Note that the master
(primary) user of the system is the only one who can assign codes to secondary (or temporary)
users, and is user number 02; user number 01 is reserved for the installer of the system.
All codes can be used interchangeably when performing system functions (a system armed with
one user's code can be disarmed by another user's code), with the exception of the babysitter
code described below.
Babysitter Code
This code can be used to arm the system in assigned partitions, but cannot disarm the system
unless
the system was armed with this code. This code is typically assigned to someone (such
as a babysitter) who has a need to arm/disarm the system only at certain times. The babysitter
code is assigned to user 15. The user of this code should
not
use the ÒQuick ArmingÓ feature
described below.
Duress Code
This feature is intended for use when you are forced to disarm or arm the system under threat.
When used, the system will act normally, but can silently notify the Customer Care Center of
your situation, if that service has been provided. Duress code is assigned to user 16.
Important:
This code is useful only when the system is connected to the Customer Care
Center.
Quick Arming
and
Single-Button
Arming
Note that if "Quick Arming" was programmed by the installer, the
Ê
Ê # Ê
Ê
key can be pressed in
place of the security code when arming the system.
If so programmed, the ÒAÓ and ÒBÓ keys on a touchpad can be used for single-button arming
AWAY or STAY, respectively. See ARMING ALL PROTECTION and ARMING PERIMETER
ONLY sections.
The security code must always be used to disarm the system, however.
