Ð 28 Ð
TESTING THE SYSTEM
(CONTINUED)
Walk in front of any interior motion detectors (if used) and listen for three beeps. The
identification of the detector should appear on the display when it is activated. The display
will clear when no motion is detected. Note that if wireless motion detectors are used, there
is a 3-minute delay between activations. This is to conserve battery life.
To test all smoke detectors, follow the manufacturer's instructions. The identification of
each detector should appear on the display when each is activated.
If a problem is experienced with any protection point (no confirming sounds, no display),
CALL FOR SERVICE IMMEDIATELY.
When all protection points have been checked and are intact (closed), there should be no
zone identification numbers displayed on the touchpad.
When testing is completed, exit the TEST mode by continuing with step 5.
OFF
5. ÊÊÊ ÊÊÊ ÊÊÊ ÊÊÊ + ÊÊÊ
1
Ê
Ê
EXIT TEST MODE
ÊÊÊ
(Security Code)
Enter your security code and press the OFF key.
If the test mode is inadvertently left active, it automatically
turns off after 4 hours.
