Adp Series 4000, Руководство по установке

Страница: 14 / 64

Chapter 1 Before You Install the Series 4000 Timeclock
1-6 ADP, Inc.
Ethernet Cabling Considerations
The Series 4000 timeclock supports 10BASE-T or 100BASE-T Ethernet
communication and autosensing between 10Mbit and 100Mbit. Ethernet
communication requires an RJ-45, 8-wire connection.
Note
Ensure that your Ethernet cable meets all applicable wiring code specifications.
Note the following important information:
!
If you plan to run Ethernet cable through the wall to the timeclock, run the
cable before you install the timeclock. Ensure that the cable exits the wall at a
point where it can enter the installed timeclock, and that you provide at least
20 inches (50.8 cm) of slack from the point of entry into the timeclock.
Instructions for marking the point of entry into the timeclock are presented in
“Preparing the Location of the Timeclock,” beginning on page 2-2.
!
To connect to an external wall jack, install the timeclock in a location that
allows an easy and secure connection to the jack. You must run an Ethernet
cable from its connection inside the timeclock, through a conduit hole in the
bottom of the base, and to the external jack.