ADOS S.R.L. Buccinasco (MI)
417-MTA200I1
Rev. 9
Page 45 of 77
3.
INSTALLATION
3.1 Material
receiving
Remove the instrument from its packing and check if it has been damaged during transport.
Claims for any damage must be submitted immediately and in writing to the supplier and to the
carrier which delivered the goods.
The instrument should be delivered with the following :
•
1 6 pin male circular connector kit for load cell wiring
•
1 kit of removable female terminal blocks for power supply and I/O wiring
•
2 attachment brackets
•
1 copy of the instruction manual
•
2 copies of the instrument testing certificate (check that the serial no. reported in the special area
on the back corresponds to what is reported on the testing sheet)
3.2 Instrument
mounting
The instrument is designed for panel mounting. The cut-out dimensions are indicated in Figure 2.
Insert the instrument, hook the two attachment brackets into the special holes located on the side of
the box. Then, use a screwdriver to adjust the set screws until the front frame is flush with the
board.
For the necessary depth, consider the length of the instrument plus about 5 cm for the connection
cables.
1
2
3
4
5
C
E
0
9
8
7
6
ZERO
0
G
N
NET- GROSS
TARE
T
F
0
G
N
MOTION
Kg
Lb
L1
FAULT
96
188
140
91
192
Figure 2 - A200E drilling template
