Page 3
INTRODUCTION
The T200F is a weight transmitter to be combined with the load cells to detect the weight in every
situation.
The module is easy to install and must be mounted on a 35 mm DIN rail or OMEGA bar. The weight,
the status of the instrument, the setting parameters and any errors are all clearly shown on the display.
The 4 capacitive keys below the display permit easy use of these functions: ZERO-SETTING, TARE,
GROSS/NET switching, setting of the weight set-points, configuration, and both theoretical and real
calibration.
The T200F uses the RS232 serial port with ASCII protocols, in order to be connected to a PC, PLC
and remote units with a maximum distance of 15m, above which you must use the serial port RS422/
RS485 which also allows connection with the MODBUS RTU protocol up 32 addressable instruments.
Availability of the most widespread fieldbuses, as an alternative to port RS485, also makes it possible
to interface the transmitter with any supervision device currently offered by the market.
There is also a USB 2.0 port for easy interfacing with the PC via a utility software which can be pro-
vided with it.
They are always 2 programmable weight set-points and control of the maximum weight value reached
(peak).
In addition you can have the analog output in current or voltage even with a FIELDBUS.
Available versions:
•
T200F:
weight transmitter with RS232 serial output, USB, RS485 and peak function. Supported
protocols are Modbus RTU, continuous, slave and on demand. Two programmable set points, 2
inputs and Peak function.
•
T200F/A:
version with the analog output.
•
T200F/PROFINET:
weight transmitter with RS232 serial output, USB and PROFINET.
•
T200F/ETHERNET IP:
weight transmitter with serial output RS232 and ETHERNET IP.
•
T200F/ETHERCAT:
weight transmitter with serial output RS232 and ETHERCAT.
•
T200F/ETHERNET :
weight transmitter with serial output RS232 and ETHERNET.
•
T200F/PROFIBUS:
weight transmitter with serial output RS232 and PROFIBUS.
•
T200F/CANOPEN :
weight transmitter with serial output RS232 and CANOPEN.
ADN
Pesage
