Adler ADCHARGER 15, Инструкция по эксплуатации, Страница: 10 / 11

TROUBLESHOOTING
Some minor problems often can be solved by the user. Please
read this chart for possible solutions to common problems.
PROBLEM POSSIBLE CAUSE SOLUTION
The battery is
connected and the
charger is on, but
it isn't charging. The charger is not
in the charging
mode.
Press MODE DISPLAY
button until the battery %
or the voltage reading
goes on.
Indicator lights are
lit in an erratic
manner not
explained in the
manual. A button may have
been pressed when
the charger was
plugged in.
The charger may be
defective. Make sure nothing is
touching the control
panel, then unplug the
unit and plug it in again.
The green FULL
CHARGE LED
turns on a few
minutes after
connecting to the
battery.
The battery may be
fully charged or
recently charged,
leaving the battery
voltage high enough
to appear to be fully
charged. If the battery is in a
vehicle, turn the
headlights on for a few
minutes to reduce the
battery voltage and try
charging again. Also try a
lower
CHARGE RATE
selection.
The charger was
unplugged from
the mains but the
display is still on. The battery is
supplying the power
to the display. Disconnect the battery.