ADJ Products, LLC - www.adj.com - Jellyfish IR Instruction Manual Page 14
ADJ Products, LLC - www.adj.com - Jellyfish IR Instruction Manual Page 15
Jellyfish IR
UC IR Control
Jellyfish IR
Master-Slave Set Up
This function will allow you to link up to 16 units together and
operate without a controller. In a Master-Slave set up one unit
will act as the controlling unit and the others will react to the
controlling units programs. Any unit can act as a Master or as a
Slave.
1. Using standard XLR microphone cables, daisy chain your
units together via the XLR connector on the rear of the units.
Remember the Male XLR connector is the input and the
Female XLR connector is the output. The first unit in the
chain (master) will use the female XLR connector only - The
last unit in the chain will use the male XLR connector only.
For longer cable runs we suggest a terminator at the last fix-
ture.
2. On the Master unit press the MENU button until “SLND” is
displayed, and press ENTER. Press the UP or DOWN button
until “MAST” is displayed, and press ENTER to confirm.
Now, select your desired operating mode and set that show
by pressing the ENTER button.
3. On the slave units press the MENU button until “SLND” is
displayed, select your desired Slave mode and Press ENTER.
4. The slave units will now follow the Master unit.
With this feature you can connect the fixtures to one another
using the IEC input and output sockets. The quantity that can be
connected is 28 fixtures maximum for 120V and 46 fixtures maxi-
mum for 230V. After the maximum amout of fixtures is connected
you will need to use a new power outlet. They must be the same
fixtures. DO NOT mix fixtures.
Jellyfish IR
Power Cord Daisy Chaining
The UC IR (sold separately) infrared remote gives you control of
various functions (See below). To control the fixture you must aim the
remote at the front of the fixture and be no more than 30 feet away.
The Jellyfish IR comes with the Airstream IR remote transmitter.
The transmitter plugs into the headphone jack of your iOS phone
or tablet. To control your IR fixture you must raise the volume to the
maximum on your iOS phone or table and aim the transmitter at the
front of the fixture and be no more than 15 feet away. After you have
purchased the Airstream IR transmitters, the app is a free download
from the app store for your iOS phone or tablet. The app comes with
3 pages of control depending on the IR fixture you are using. Please
see below for IR functions including the corresponding app page.
Works with App page 1.
STAND BY
-
Pressing this button will blackout the fixture. Press the
button again to return to the initial state.
FULL ON
-
Hold this button down to fully light up the unit. When you
let the button go, the unit will return to its previous state.
FADE/GOBO
-
This button is invalid for this fixture.
“” and “DIMMER -” -
Use the buttons to adjust the output
intensity.
STROBE
-
Press and hold this button for strobing.
COLOR
-
Press this button to activate color mode. Use buttons 1-5
to select your desired color.
1-9
-
Use buttons 1-9 to select your desired color when color mode
is active or your desired show when show mode is active.
SOUND ON & OFF -
Use the buttons to activate and deactivate
sound active mode.
SHOW 0 -
Press this button to select Show 0. Use buttons 1-9 to se-
lect Shows 1-9. Press the Show 0 button twice to run Show 10, and
press button #1 twice to run show 11.
