ADIATEK quartz 66, Использование и обслуживание

Страница: 13 / 23

13
Even in the 3S mode to enable the emission of detergent solution the
solenoid valve button has to be pressed (2).
If the detergent solution is disabled the display will show the disabled
solenoid valve symbol.
WORK
A safety device avoids the machine’s movement if the operator is not
properly placed on the footboard.
To turn on the machine:
1. Step on the footboard.
2. Turn the key (1) clockwise to turn on the machine.
3. Check the battery level on the display.
The machine will go automatically in manual mode (MAN).
MANUAL MODE WORK
1. Check that the machine is set in manual mode, if not press
button (1) and the display will show the corresponding symbol.
2. Press the suction motor button (2); the suctin motor symbol
changes depending if the motor is turned on or off, the motor
will then start to work.
3. Press the solenoid valve button (3); the solenoid valve symbol
changes depending if the valve is closed or open
4. Lift down the brush base on the floor pressng button (4); the
display will show first the lifting down symbol and then the
brushes on symbol.
5. To lift down the squeegee press the button (6).
6. While running the first meters check that the squeegee
adjustment guarantees a perfect drying action and that the
detergent solution flow is appropriate. It has to be sufficient to
wet the floor uniformly avoiding the leakage of detergent from
the splash guards. Always consider that the correct quantity of
solution detergent depends on the type of floor, dirtiness and
machine speed.
BRUSHES PRESSURE ADJUSTMENT
The brushes pressure can be
adjusted only in manual mode,
if not in that mode press the
button (1).
To adjust the pressure press two
times button (2).
On the display value P1, P2 or P3 will blink.
Press the buttons (+) and (-) to select the pressure, the value will set
once it will stop blinking on the display.
SPEED ADJUSTMENT, FORWARD AND BACKWARD
Before running the machine select the maximum speed level during
work. Press buttons (+) and (-) to see the speed level on the display.
To move the machine select the
direction using the lever (1)
placed on the dashboard.
Press the pedal (2) placed on the
footboard to enable the speed.
Use the knob (3) to adjust the
speed during work. The speed
will change from the minimum
to the maxium previously set
and visible on the display.
If backward movement is selected the brush base will stay down, the
squeegee will lift up and the suction motor will shut itself.
When the forward movement will be selected again the squeegee will
go down and the suction motor will turn back on.