ADIATEK quartz 66, Использование и обслуживание

Страница: 12 / 23

12
Use only brushes supplied with the machine or the ones indicated in
the manual “RECOMMENDED BRUSHES”. The use of other brushes can
compromise the good washing result.
FLOOR CLEANING
CONNECTING THE BATTERY CONNECTOR AND SWITCHING ON
THE MACHINE
Once that the battery recharging has been completed:
1. Disconnect the connector (2) of the battery recharger from the
battery connector (1).
2. Connect then the battery connector (1) to the machine
connector (3).
RECOVERY TANK
Verify that the squeegee hose coupling (1) is correctly inserted into
its seat and that the exhaust hose plug (2) is well closed.
The recovery tank is provided with a cover (3) that blocks itself thanks
to the vacuum created by the suction motor during the use.
The avoide the tank to open accidentaly use the block (4).
DETERGENT SOLUTION TANK
The solution tank is provided with an inspection hole. This hole allows
to clean the exit area of the detergent solution.
Be sure that the cap is closed tight.
The capacity of the detergent solution tank is indicated in the
technical data.
Open the screw plug placed in the left part of the machine and fill
the detergent solution tank with clean water at a maximum
temperature of 50°C. Add the liquid detergent in the percentage and
conditions foreseen by the manufacturer. To avoid excessive foam
presence, which could cause problems to the suction motor, use the
minimum percentage of detergent. Screw down the plug to close the
tank.
On the rear part of the machine is placed a level hose that permits to
see easily the solution quantity inside the tank both during the filling
of the solution and during the working.
Screw the solution tank cap.
Use always low foam detergent. To avoid foam presence, before
starting working operation, introduce into the recovery tank a
minimum quantity of anti-foam product.
Never use pure acid.
3S SOLUTION SAVING SYSTEM (OPTIONAL)
It is a system that allows the controlled use of the detergent solution
during work.
To turn it on press button (1)
two times, then on the display
the water symbol will blink.
Select the 3SD system using
buttons (2).
When the 3S stops blinking the system is being selected.
SELECTING THE FLOW RATE - 3S SYSTEM
Using the flow rate button (1) the H value can be adjusted from H1
to H7.