ADIATEK quartz 66, Использование и обслуживание

Страница: 10 / 23

10
BATTERY CHARGER
Make sure that the battery recharger is suitable for the installed
batteries both for their capacities and type (lead/acid or GEL and
equivalent).
In the plastic bag containing the use and maintenance you will find
the coupling connector for the recharger. It must be assembled onto
the cables of your recharger, following the instructions given by the
manufacturer.
ON-BOARD BATTERY RECHARGER (OPTIONAL)
If the machine is equipped with the incorporated battery recharger
(see under "OPTIONAL ACCESSORIES”) please refer to the instructions
of the constructor of this accessory what the recharging operations
concern.
The battery recharger is connected directly to the battery poles.
During the charge a system is activated that do not allow the
machine functioning.
The battery charger cable have a maximum length of 2 meters and
must be connected to a single phase plug CEE 7/7 type
BATTERIES CHARGE LEVEL INDICATOR
The battery charge level is visualized on the display with its respective
symbol (see " CONTROLS DISPLAY").
When the last segment of charge starts blinking, the
battery is almost low and the suction and brushes
functions are disabled.
When even the last segment of charge turns off, the
battery is completely low and the machine stops.
BATTERY CHARGING
BATTERIES RECHARGING
1. Plug the connector (2) of the battery recharger into the battery
connector (1).
2. Proceed for the recharging.
Once that the battery recharging is completed:
3. Disconnect the connector of the battery recharger from the
battery connector (1).
4. Connect instead the machine connector (2).
BATTERY CHARGING USING THE ON-BOARD BATTERY CHARGER
(OPTIONAL)
Take the machine to a plain surface near a power plug.
1. Turn off the machine using the key switch.
2. Insert the plug into the mains socket.
3. Proceed to the recharging keeping the recovery tank lifted (see
paragraph “ACCESS TO THE BATTERY COMPARTMENT” in
“BEFORE USE”).
4. Do not take off the plug from the mains socket until the
indication of the end of charge is not visualized.
At the end of the recharging, take off the plug from the mains
socket.
Never charge a GEL battery with a non suitable recharger. Strictly follow
the instructions supplied by the batteries and recharger manufacturer
NOTE: Never leave the batteries completely discharged for long
periods even if the machine is not used. In case of traditional
batteries, please check the electrolyte level every 20 recharging cycles
and eventually fill them up with distilled water. Never leave the
batteries discharged for more than two weeks.
If lead/acid batteries are installed there could be the risk of gas
exhalations and emission of corrosive liquids.
Fire danger: do not approach with free flames.
BATTERIES DISPOSAL
It is compulsory to hand over exhausted batteries, classified as
dangerous waste, to an authorized institution according to the
current laws.