ADENDORFF ZAY7045FG, Руководство по эксплуатации

Страница: 8 / 23

I
I -L
I -M
I
1 -H
11-L
JI -M
I ]J -H
I
80
145
260
37.� I 110
[ 1250
I
95 175
310
450
850 1500
7. lnstal I ing and changing tools
I WARNING: BE SURE THE POWER IS TURNED OFF AND THE MACHINE
I
UNPLUGGED BEFORE INSTALLING OR CHANGING TOOL BITS.
(!)Removing face mill or drill chuck arbor.
Loosen the arbor bolt at the top of the spindle shaft approximately
2 turns with a wrench. rap the top of the arhor bolt with a ma]] et. After
taper has been broken loose, holding chuck arbor on a hand and turn
the arbor bolt with the other hand.
(2)To install face mill or cutter arbor
Insert cutter and cutter arbor into the taper of spindle. Tighten arbor
bolt secure] y, but do not overtighten.
(3)Removing taper drills
(a) Turn down the arbor bolt and insert thc-.· taper dri 11 into the spindle
shaft.
(b) · Turn ·- down the rack sleeve until the oblong hole�in -the rack - sleeve-- - ­
appears, lock the rack sleeve, insert wedge though holes and strike
lightly with a mallet, this will force the taper drill out.
8.0rdering replacement parts
Complete parts list is attached, if parts are needed, contact your local
di stri but or.
9. Additional tools and accessories you wi 11 find helping
Each of machine is equipped with a M. T. 3 ur RB, contact your local
distributor or a main cutting tool distributor to obtain any of these
accessor1 es.
Taper dri 11
Reamers
End mills
Cutter arbor
Taps
Col lets
Adapters and sleeves
10.Specification of the T-slot
Please refer to figure, purchase or
make T-bolts and other table
top fixtures to these dimensions.
8