ADENDORFF ZAY7045FG, Руководство по эксплуатации

Страница: 7 / 23

(6)Adjust the positive depth stop gauge according to working depth.
(7)Adjust
the .scale sjze
accord.ing to ,rnrking need.
2. Dr i I I i ng operation
(1)
For
dr
i
11
ing
blind
hole (which
do
not pass through
th€
workpiece), turn
off the knob make loose the taper body of worm gear and spring base,
then adjust the positive depth stop gauge so that the distance from
the tip of the drilling bit to the end of the blind hole is equal to
the desired depth.
(2)For drillling pass hoJe(which pass through the workpiece),set the
positive depth stop gauge in its uppermost position.
3. Mi I I ing operation
(l)Adjust the positive stop depth gauge to its uppermost pos1t1on
(2)Lsing the spindle feeding handle, adjust the cutter to approximately
the correct height, turn off the knob make tighten the taper body·of
worm and spring base.
(3)Set the working depth by using the micro feeding handle.
(4) Lock the rack sleeve at the height with the fixed bolt.
(5)
When longitudinal feeding milling, it is a good idea to lock the across
feeding table to ensure the accuracy of your work. To do this. tighten
the two screws located on the right side of the table base.
(6)�When cross feeding_mi_lling,_ lock the longi'tudinal _feeding _traveJ., _________
do this by tightening the two screws on the front of the table base.
4. Tapping operation
(l)Loosen the knob in the center of the spindle feeding handle.
(2)Adjust the positive depth gauge to the required position.
(3)The switch pojnt to "tapping". When tapping is overload, press down
the red emergency switch, and the spindle reverse, the taper turn out.
5. Adjustment
(l)Adjustable moveable fixed rings are mounted on the front of the table
to limit cross travel.
(2)Your machine is equipped with gib strip adjustment to compensate for
wear and excess slack on cross and longitudinal travel.
(3)Rotate the gib strip bolt slightly clockwise to tighten the gib trip.
rotate it slightly counter-clockwise to loosen the gib trip.
(4)Adjust the gib trip bolt until very slight drag is felt when moving
the table.
6. Changing machine speed
(l)Turn the power off.
(2)To select the proper speed, move the speed lever to the desired position .
(3)If the gear are not engaged, remove the arbor bolt cover. rotate the
spindle slightly to engage the gears, then replace the arbor bolt cover.
(4) Recheck the 1 ever setting, then turn the power on.
7