ADENDORFF ML392CI, Руководство по обслуживанию

Страница: 13 / 21

12
●
Operator should stand at the position of Fig.9. Instructions for use
●
Always advance the wood uniformly and slowly.
●
Check that the wood doesn't have splittings or dangerous knots and always pass the
concave part towards the tables.
●
Avoid to pass short and small-dimensioned workpieces and, if necessary, use special flat
holders.
●
For long workpiece use supports in outfeed.
●
Keep the knives sharp and don't have cracks.
●
For any sudden trouble or accident, press the E-button 11.
●
At the end of work, turn-off the machine and clean the table.
●
At the end of work, cover the knives with guide 3.
7.3 Press planing (Fig.11)
Fig.11 Press planing diagram
1.front guard 2.front bench 3.press planing table 4.outfeed roller 5.bridge guard 6.cutter spindle 7.infeed roller
8.anti-kickback jaw 9.back bench 10.back guard
This operation is necessary for machining the third and fourth side of the wood piece which is
already planed on the first and second side in order to obtain the finished workpiece.
Preparation
●
Turn-off the machine and make sure that nobody may start it accidently.
●
Remove the drill bit and sawblade, mount spindle hood 1 and cover 9 (Fig.9)
●
Cover the arbor 6 with bridge guide 5. The bridge guide is 3
～
4cm apart from the arbor.
●
Turn-up the guide 10.
●
Check that anti-kickback jaw 8. They should be free to fall down with their own weight. If
not, clean them with brush.