ADENDORFF ML392CI, Руководство по обслуживанию

Страница: 16 / 21

15
1.drill bit 2.drill hood 3.bolt M8
×
12 4.front bench 5.ruler base 6.arbor cover7.lock lever 8.sawing & planing
guide 9.lock lever 10.saw safety cover 11.sawing table
let the cutters extend over the toolpan at the same height, when straight edge cutter need to
be mounted, the diameter of cutter edge is 74mm, when shaped edge cutters need to be
mounted, the max. diameter of tool edge is not more than 104mm.
●
Mount toolpan 4 and spacer 5 in proper order and then lock by nut 6.
●
Adjust the position between bench and tool pan according to the width of the workpiece,
then tighten the bench.
●
Mount milling hood 3, let the milling feeding presser (used as anti-kickback jaw) and the
outfeed presser press the workpiece dependably. The adjusted natural height should be lower
than that of the level of milling cutter.
●
Change-over switch 1 in the position of R (Fig.14). Infeed direction is the same as press
planing direction. The milling depth is about 3mm. The Max. depth is not more than 5mm.
●
The operator should stand at the left and back side of the machine.
8.2 Instruction for use
●
Wear goggles.
●
Keep the knives sharp, clean and the same weight.
●
Check that the wood doesn't have splitting or dangerous knots.
●
Always advance the wood uniformly and slowly.
●
Never low the table before the spindle stops completely.
●
Press button 2 (Fig.14) if there is something wrong.
●
Be sure to keep the arbor in well condition and covers in good position and fixed well.
●
At the end of work remove the cutter, clean chips, mount spindle hood.
9 Drilling
Hole or half-holes can be carried out