ADEMCO VISTA-128B, Руководство по установке и настройке, Страница: 72 / 208

VISTA-128B Installation and Setup Guide
12-4
2K ELOR
2K ELOR
TAMPER SWITCH
(CONTACTS CLOSE WHEN
SWITCH DEPRESSED.
LOCK SWITCH
(NORMALLY OPEN)
+
TO J7 / OUT 2
TO J7 / OUT 4
TO AUX POWER
(TERMINAL 6)
ZONE
ZONE
TO ZONE 7 (+)
(TERMINAL 20)
YELLOW WHITE
GREEN
(READY)
RED
(ARMED)
RED BLACK
820
ohms
820
ohms
Figure 12-4: Remote Keyswitch Wiring
Keyswitch Operation With System Disarmed and No Alarms Present:
A momentary short across zone 7 will arm the partition in the AWAY mode, and a short held
for more than 10 seconds will arm the partition in the STAY mode. A subsequent short will
disarm the partition. The keyswitch LEDs indicate the partition status (see table below).
Faulted zones must either be corrected or bypassed before the system will arm.
Keyswitch Operation With Alarms Present:
A momentary short across Zone 7 will silences alarm bell and keypad sounds, and disarms
the system if it was armed. The keyswitch LEDs provide a memory of alarm indication (see
table below). A subsequent short across Zone 7 will clear the alarm memory indication and
reset 2-wire smoke and glassbreak detectors (if used).
LED INDICATIONS
GREEN RED MEANING
OFF OFF DISARMED AND NOT READY
ON OFF DISARMED AND READY
OFF ON STEADY ARMED AWAY
OFF SLOW FLASH ARMED STAY
OFF RAPID FLASH ALARM MEMORY
If Open/Close reporting for the keyswitch is enabled in field *40, the keyswitch reports as user 0.