ADEMCO VISTA-128B, Руководство по установке и настройке, Страница: 179 / 208

Section 29 - Keypad Functions
29-7
nn DEVICE IS OFF
HIT THE "*" KEY
Voice: "’VOICE DESCRIPTOR’ DEVICE ‘NN’ ON/OFF. TO EXIT,
ENTER 00 NOW"
From a keypad, press [
∗
] to continue. The ENTER DEVICE NO.
prompt will appear.
From a telephone keypad, enter 00 to exit, or enter the next relay
number to be programmed. The current on/off state of that relay
will be annunciated as described above. Alternatively, if 6 seconds
elapses with no key depression, the voice module will annunciate
the "ENTER DEVICE CODE NOW" message.
A relay may be designated as restricted to prevent inadvertent activation/deactivation by
users. Only the Installer Code can override this restriction in Output Programming in the
#93 Menu Mode Programming
Instant Activation Mode (#77 Mode)
The #77 Instant Activation Mode is used to activate outputs, bypass zones, etc. immediately
upon exiting the #77 Mode. The actions that may be activated by the operator are relay
commands, arm/disarm commands, zone bypassing commands, and open/close access
conditions.
1. Enter [User Code] + [#77].
2. Enter the code for the desired action and action specifier. The action codes are the
events that are to take place when either the system exits the #77 Mode or the scheduled
time is reached, depending on the action selected. Each action also requires an action
specifier, which defines what the action will affect (relay, relay group, partition, zone list,
user group). The action specifier varies, depending on the type of action selected.
Refer to Time Driven Events in the Scheduling Options section for a listing of the “Action
Codes” (desired actions) and “Action Specifiers.” Note that these codes are independent of
the
actions
programmed during the Output Programming in the #93 Menu Mode.
NOTES:
•
Only the Installer and Master levels user codes may perform the Instant Activation
Mode.
•
When performing an arm or disarm, the user must be assigned to the partition being
activated.