ADEEPT Robotic Arm, Руководство пользователя

Страница: 149 / 182

146
arm in the Y motion state, press the "BUTTON" button on the drive board for about
2-3 seconds to release it, at this time, the "remaining steps: 9" item on the OLED
screen The number will decrease by 1, indicating that the robot arm has successfully
recorded the movement state in Y.
(3) Repeat the operation of step 1 until the number of "remaining steps: 9" on the
OLED screen will be reduced to 0, and the robotic arm will complete the recording
and automatically run all the motion states just recorded.
(4) Press the "RESET" button on the Adeept Arm Drive Board to restart the
robotic arm to exit the automatic motion mode. At this time, the robotic arm is in the
learning mode, so you can continue to repeat step 1 to re-record other motion states or
actions.
(5). After the robotic arm is re-powered or restarted, press the "BUTTON" button
for more than 8 seconds to enter the automatic motion mode, and the robotic arm will
automatically run the motion state or action recorded last time.
【
Note
】：
1.The robotic arm product we provide is used for learning and experimentation. It
cannot complete difficult imitation actions. It is recommended that you use it to
complete some simple imitations, such as drawing triangles and line segments.
Because everyone's abilities are different, errors will occur during operation. You
often practice it. After you are familiar with it, you will find it very interesting. The
important thing is that you can get other inspirations through the features of this
product.
2.Please use a fully charged battery.
3.If you turn any of the potentiometers, the corresponding servo does not work,
then you need to restart the robotic arm.