STAN07-210324-Rev005-UM-en
16
Use the keys as follows:
▲
Increases the value of the selected character.
▼
Decreases the value of the selected character.
►
Selection of the next menu item.
Jumps to the next character to the right.
◄
Selection of the previous menu item.
Jumps to the next character to the left.
Selection of the menu and the menu item.
Selection of the next sub-item.
Change of sub-item in the menu item.
Change of menu item in weighing mode.
The following diagram shows the sequence of the parameters:
Meaning of symbols:
Selection of the next step according to the parameter diagram.
Holding the key for more than one second makes the next item appear.
Repeatedly press this key to skip parameters.
In operation.
Input values using the navigation keys ▲, ▼, ►, ◄.
Storing target values - PLU memory menu [PLUPrO]
Stored target values in a PLU are required for check weighing in weighing mode.
The procedure for storing and recalling the PLU values is further described above.
Storing target amounts - ALU memory menu [ALUPrO]
Stored target quantities in an ALU are required for quantity inspection in piece counting mode. The
procedure for storing and recalling the ALU values is further described above.
Storing average piece weights - CLU memory menu [CLUPrO]
Stored CLU piece weights are required for piece weight inspection. The procedure for storing and
recalling the CLU values is further described above.
Settings for the audible signal [bUZZEr]
In this menu item, you can make the basic settings of the audible signal as well as warning tone settings
for tolerance weighing and tolerance counts and the keyboard.
To configure, hold the
key for more than one second until [PLUPrO] appears in the display. Then
repeatedly press the ► key until [bUZZEr] appears in the display.
