Stereo Sound & CD-ROM
4.3.1 CD-ROM Device Driver Installation
Put the diskette into your floppy drive, change to drive A or B. At the
system prompt, changes the subdirectory by entering:
A:\>cd \CDROM\PANASONI [Enter]
or
B:\>cd \CDROMVPANASONI [Enter]
.depending 011 which drive you use. An installation routine
CDINSTL.EXE has been provided to assist you installing the
software. Assuming you are in A, enter:
A:\CDROM\P AN ASONI>CDINSTL [Enter]
This program will guide you step by step to setup CD-ROM device
driver parameters. Please refer to the section below to learn more
about how to change device driver parameters.
You may manually install the driver, by completing the following
steps:
Step
1. Use any text editor to add the following two lines to the file
"CONFIG.SYS"
under your boot hard disk root-directory
(Drive C in general).
O Device=[drive:]\[path] CDMKE.SYS
[/Didevice name]
[/P:xxx]
O LASTDRIVE =
drive letter
/Didevice name
specify device driver name that is used by the Microsoft MS-DOS
CD-ROM extension file MSCDEX. MSCD000 is the commonly
used device driver name, when none is specified.
/P * XXX
xxx is the I/O port address as set on SI of the sound card. The
default is 320H.
/Last d rive
letter
Enter the proper drive letter name
according to your system configuration. For example, if you
already have 3 hard drives, use "f\ If this qualifier is not
specified, the default used by DOS is "e".
Page -12
