9
To select a computer using hotkeys
Using hotkey combinations, you can quickly switch the keyboard, video monitor,
mouse and speakers and USB peripherals to any computer channel.
There are two mains ways to use hotkeys:
Standard
and
Additional
.
Standard hotkey press combinations
The standard hotkey press combinations allow you to change channels with the
minimum of keypresses:
1 Simultaneously press and hold
and
.
2 While still holding
and
, press the number key of the required
channel address (or the TAB key), then release all of the keys.
Note: The numbers on your keyboard’s numeric keypad are not valid, use
only the numeral keys above the QWERTY section.
The ports (KVM, audio and/or USB) that are switched using this method
depend upon the switching mode that is currently set using either the
The range of standard hotkey combinations are as follows:
Note: If your hotkeys have been changed, substitute them for
and
in
the examples given here.
Selects channel 1
Selects channel 2
•
•
•
•
Selects channel 8
Blanks the video
Selects the next channel (see note
)
What are hotkeys?
The
and
keys when pressed in combination are called ‘hotkeys’ and
they signal to the AdderView Pro 8 DVI that you wish to control it, rather than
the computer. However, if these particular hotkeys clash with another device
or program, you can change them to a different combination within the Setup
Options menu.
Additional hotkey press combinations
In addition to the standard hotkey press combinations (shown left), you can also
add additional keypresses in order to determine which peripherals are switched:
1 Simultaneously press and hold
and
.
2 Press and release a command key:
A
to switch all peripherals
K
to switch only the keyboard, video and mouse
S
to switch only the speakers
U
to switch only USB1 and USB2
3 Press and release the required channel number (1 to 8 using only the keys
above the QWERTY section).
4 Release
and
.
The appropriate peripherals will change to the chosen channel.
Note: Regardless of which peripherals were switched, the front panel
indicators will continue to show the switching mode that was last
determined using either the on-screen menu or the front panel switches.
Choosing which computers are accessed when using hot keys + tab
The computer channels that are visited when you use the hot keys + tab are
determined by the
setting within the Global Preferences menu:
• ALL PCs - visits all channels regardless of computer status,
• ACTIVE PCs - limits the choice of channels to those with active computers,
and
• SCAN LIST restricts selection to those channels specifically marked for
inclusion (see
for more details).
