BANKS and PRESETS
ADDAC112 User’s Guide
page 5
ADDAC SYSTEM
BANKS:
In order to make the LOAD/SAVE process simple one can only LOAD BANKS from the SD Card.
BANKS contain a list of PRESETS and a folder with a list of LOOPS.
Each BANK is saved into a folder in the SD CARD, inside the folder, together with a document contain-
ing all presets configurations, the user will find a second folder with all LOOPS in separate.WAV files.
While Saving or Loading from the SD Card the audio processing will be suspended, it may take up to
10 seconds to save a full Bank.
Once the BANK is loaded to memory jumping between LOOPS will be immediate.
A new BANK can be created at any time using the MENU: NEW BANK.
BANKS initialize with an empty list of PRESETS and LOOPS.
At the moment of creating a new BANK the user will be asked to choose from 2 options:
(New)
1. Current Config, copies the current BANK settings into the new BANK
2. Default Config, creates a new BANK with factory default settings.
Powering up the module without any SD Card will automatically create a new Bank, this Bank will be
initialized with factory default settings.
Each BANK stores a list of up to 99 PRESETS as well as all loops used by all these PRESETS.
Upon startup the module will automatically load the last BANK saved.
All recording is written and read from volatile memory if the BANK is not saved to the SD ard Card all
data will be lost once a new BANK is loaded or power is turned off!
Users can share Banks among themselves by sharing the Bank folder.
PRESETS:
Each PRESET contains a list of LOOPS and all Granular Settings.
Each PRESET can have shared or unique LOOP lists.
PRESETS can be saved at any time using the MENU: SAVE PRESET
PRESETS can be added to the list using the MENU: NEW PRESET, this new PRESET will be created
with the current Granular settings.
As PRESETS are changed via the [PRESET SELECT] control knobs will not reflect the current values of
the front panel controls and, in this case, they will seem not to have any effect, to make them
effective once again the user must rotate the knob until it crosses the preset setting and then the
knob will become active once again.
At all times rotating the [PRESET SELECT] to the left most position will enter preset “-” in this state all
knobs always correspond to the front panel controls.
If new LOOPS or PRESETS are recorded at any point in time remember that they are not yet saved to
the SD Card, saving the current BANK before loading a new BANK or before power down is necessary
to keep all it’s contents safe in the SD Card!
Edited
