ADC Soneplex Soneplex Fiber Hub Cabinet SPX-CABFIN04, Руководство пользователя

Страница: 47 / 84

LTPS-UM-8007-01, Issue 1 Installation
SPX-CABFIN01, SPX-CABFIN04 November 9, 2001 35
Figure 29. Removing Battery Cover Knockout Panel
26 Place the protective plastic covers on the battery.
27 Ensure that all battery cables are dressed to clear the opening as the drawer is closed.
T
URNING
U
P
B
ATTERIES
1 Verify that all batteries are properly installed.
2 If the batteries:
–
are in one 6V string, proceed to Step 4.
–
are in two 12V strings, continue with Step 3.
3 Isolate the first and second battery strings:
–
At the DC distribution panel, operate the battery disconnect (by inserting the pin provided at the
right-hand side into the BATTERY DISCONNECT jack shown in
Figure 30 on page 36 ), or:
–
Disconnect any one connector from the battery connector bus for the second string of batteries.
Do not install the battery drawer cover at the front of the battery drawer at this time.
Before starting this procedure, verify that the rectifier modules have not been installed, or are
turned off. If the rectifier modules are powered up, DMM indications will show rectifier output
instead of battery voltage.
A Fluke 79 Digital Multimeter (DMM) and TL20 Industrial Test Lead Set (or equivalent) are needed
to complete this procedure.
Remove the middle panel on
one side with pliers, flex
the panel until it snaps off.