ADC Soneplex Soneplex Fiber Hub Cabinet SPX-CABFIN04, Руководство пользователя

Страница: 43 / 84

LTPS-UM-8007-01, Issue 1 Installation
SPX-CABFIN01, SPX-CABFIN04 November 9, 2001 31
Figure 24. Temperature Compensation Module Installed
12 At the (+) and (-) end terminals of each battery, remove one nut, one lock washer, and one flat washer.
13 Before connecting the battery cables, coat each terminal stud with a small amount of No-Ox or petroleum
jelly.
14 At battery No. 1, place the lead from battery cable No. 1 marked positive (+) on the battery positive (+)
terminal. Install the flat washer and lock washer, and install (but do not tighten) the terminal nut.
15 At the negative (-) battery terminal, attach the other lead from battery cable.
Do not loosen the large hex nut at the base of the terminal stud. Do not remove the factory-fitted
pole connectors (large metallic straps between cells).
Do not connect the battery string to the system until instructed to do so in the following steps.
Before connecting the batteries, verify that both rectifier AC INPUT and DC OUTPUT circuit
breakers are set to OFF.
Do not plug the battery cable connectors into the battery connector bus until all battery cables
have been securely connected to their batteries.
This is a -48 Vdc system; (+) is ground.
Temperature