Advanced Control Equipment (ACE2)
96A0357 Rev. F
Installation
© ADB Airfield Solutions All Rights Reserved
26
Figure 18:
Combo Box-Mount, Internal View
NOTE:
The ACE2 enclosure is designed to be replaced easily without having to remove any
of the mounting hardware. Follow these instructions:
1. Position the enclosure flush on its mounting surface. Level the enclosure and then open
the lid and mark or transfer punch the location of the 3/8’’ diameter holes in each of the
corners of the enclosure. Refer to Figure 19.
2. Remove the ACE2 unit, drill out the marked holes, and insert anchor hardware as
required. DO NOT DRILL THOUGH THE BOX to keep drilling chips and debris from
falling into the enclosure.
3. Carefully open the lid of the enclosure. Use ¼-20 x 1.0-inch long screws, flat washers,
and lock washers to fasten the enclosure to the wall or to rails.
4. Mount the enclosure using the top two holes then install the hardware for the bottom two
holes.
5. Attach all conduits to the bottom or to the top access plate ONLY as seen in Figure 22.
6. Protect ALL electronic equipment in the ACE2 enclosure while installing conduit to the
BOTTOM or to the TOP access plate.
