ADB Safegate ACE2, Руководство пользователя

Страница: 23 / 46

A second CVM is connected to the input of the CCR to measure these parameters. If these functions are enabled, the display
shows the following hour-meter parameters:
•
Total time the CCR has been ON xHT.
•
Time the CCR has been on Step B1 xH1.
•
Time the CCR has been on Step B2 xH2.
•
Time the CCR has been on Step 3 xH3.
•
Time the CCR has been on Step 4 xH4.
•
Time the CCR has been on Step 5 xH5.
•
Total number of the CCR OFF-ON switching cycles xC.
Note
Small x = time in hours.
Push-button 3, Select/Config, becomes active and is used only in a stand-alone L-827 or L-829 mode of operation, described
above in Push-button 2.
Push-button 4, Software Version, initiates the automatic sequence displaying the following system parameters:
•
Main Control Board Firmware Version.
•
Lamps-Out Monitor Firmware Version.
•
IRMS Firmware Version.
•
RS422 channel A network address.
•
RS422 channel A baud rate.
•
RS422 channel B network address
•
RS422 channel B baud rate.
Appearance of question marks instead of the firmware version number means the firmware is not loaded for that function.
4.3 I/O Status display
Pressing and holding push-button 4 during the Software Version sequence displays the status of the Input/Output Interface.
In this mode, read all the input and output lines. The format appears like this:
Out 87654321 or Out _ _ _ _ _ _ _ _
Inp 87654321 Inp _ _ _ _ _ _ _ _
Or a combination of the two.
Each number is linked to a different pair of pins on the input or on the output connector. If the number is displayed, the
corresponding pair of input pins has voltage on them and the corresponding relay is closed.
Note
Out ?????? means there is nothing written to the outputs since power-up and the latching relay status is unknown.
96A0357, Rev. G, 2019/11/08 17
Copyright
©
ADB Safegate, All Rights Reserved