Appendix C: Using the ICP RAID Configuration Utility
●
84
Introduction to the ICP RAID Configuration Utility
The ICP RAID Configuration utility comprises these tools:
●
The Array Configuration Utility (ACU)
—For creating and managing arrays, and
initializing and rescanning disk drives (see
page 84
).
Note:
Also available—ACU for DOS. See
page 92
.
●
A
-Select
Utility
—Serial
Select
, SATA
Select
, or SCSI
Select
, for modifying your controller
and disk drive settings (see
page 86
).
●
Disk Utilities
—For formatting or verifying disk drives (see
page 90
).
Running the ICP RAID Configuration Utility
If your ICP controller is connected to a RAID enclosure, power on your enclosure (or
enclosures) before you power on your computer.
Start or restart your computer. When prompted, press
Ctrl+A
.
During boot up, if your system has insufficient memory the following message will display.
“ICP RAID Configuration Utility will load after, system initialization. Please wait... Or press
<Enter> Key to attempt loading the utility forcibly [Generally, not recommended]”
Note:
The first time you power on your computer after you install a new controller, the BIOS
may display a configuration that doesn’t match your system’s configuration. This is normal.
Navigating the ICP RAID Configuration Utility
All the tools within the ICP RAID Configuration utility are menu-based and instructions for
completing tasks appear on-screen. Menus can be navigated using the arrows, Enter, Esc, and
other keys on your keyboard.
Using the ACU to Create and Manage Arrays
To open the ACU, start the ICP RAID Configuration utility (see
page 84
). If you have more than
one controller, select your controller, then press
Enter
. Select
Array Configuration Utility
, then
press
Enter
.
Follow the on-screen instructions to create and manage arrays, and initialize, rescan, and erase
disk drives.
Creating a New Array
To begin creating an array, select
Create Arrays
from the main ACU menu.
Only disk drives that can be used in a new array are available for selection. (Disk drives must be
initialized before they can be used in an array. See
Initializing Disk Drives
on page 85
for more
information.)
Use the Array Properties menu to modify the array’s RAID level, size, name, stripe size, and
caching settings.
Note:
For more information about RAID levels and using disk drives to create arrays, see
Choosing a RAID Level
on page 30
.