Adaptec 131CA - AAA RAID Controller, Инструкция по установке и эксплуатации оборудования

Страница: 36 / 62

4-4
AAA-131CA Installation and Hardware Guide
2
Boot diskette installation: When prompted, insert diskette #2 in
your floppy drive. After a few moments you will see a blue
screen. To setup Windows NT now, press Enter and continue
with Step 3 below.
Boot CD-ROM installation: When the following message
appears onscreen, press the F6 key and skip to Step 4 below.
Setup is inspecting your computer’s hardware…
3
Press S to skip auto-detection of your AAA-131CA array
adapter.
4
Press S again to specify an additional device.
5
Press Enter to select
Others
; insert the Adaptec Array1000CA
Family Manager Set drivers diskette in your floppy drive.
6
The screen displays the adapter drivers supported on the
diskette. Select the
Adaptec Array1000CA Family Adapter and
press Enter.
7
If you want to add drivers for other host adapters (other than
the AAA-131CA), do so at this time by pressing S and repeat-
ing Step 5 for each additional adapter and inserting the appro-
priate disk provided by the hardware manufacturer.
8
Press Enter to continue with the Windows NT operating
system setup. Follow the onscreen instructions and in the
Windows NT documentation to complete the installation.
Installing the Driver When Windows NT is Already Installed
To update or install the cda1000.sys driver if Windows NT is
already installed, follow the instructions below for the version of
Windows NT that is already installed.
Windows NT 3.51
To install the cda1000.sys driver when Windows NT 3.51 is already
installed, follow these steps:
1
Start the Windows NT Setup program. (Its icon is usually
found in the Main program group.) There is a brief pause while
Windows NT Setup scans your hardware configuration.