Adaptec 131CA - AAA RAID Controller, Инструкция по установке и эксплуатации оборудования

Страница: 15 / 62

2-3
Installing the AAA-131CA Adapter and Connecting SCSI Devices
Installing SIMM Memory
Before you can use the AAA-131CA adapter, the SIMM memory
socket must be populated with a standard 72-pin 16-MByte Fast-
page mode SIMM, as shown in Figure 2-2. (The SIMM may already
be installed in the socket.) Visit the Adaptec Web Site at
http://
www.adaptec.com/RAID for a list of approved SIMMs and vendors.
Installing the AAA-131CA Array Adapter
Follow these steps to install the AAA-131CA adapter:
Note:
If you are installing the AAA-131CA adapter in an
existing system, back up all data before continuing with
installation. You can restore this data after you reconnect your
devices and your create your array(s).
1
Turn
OFF
power to the computer and disconnect the power
cord.
2
Remove the cover from the computer case. (If necessary, refer
to the instructions in your computer documentation.)
3
Locate an unused, unobstructed, 5-volt PCI expansion slot that
supports bus mastering. Unscrew and remove the expansion
slot bracket that covers the card-slot opening.
Figure 2-2. Installing SIMM in the SIMM Memory Socket