Adam Equipment WBZ 15, Руководство по обслуживанию

Страница: 15 / 30

© Adam Equipment Company 2008
14
F6 init ZEro
Initial Zero Range
F7 rE ZEro
Re-Zero range
F8 SCSivE tArE
Successive Tare Enable
F9 Ad Count
Display the A/D counts
F10 round
Rounding off the Total Price
F11 ZEro
Select the zero mode
F12 Lvd mod
Low voltage detection
F13 CAL batt
Set calibration of battery voltage measurements
F14 ACLr
Not active,
F15 Cal Cnt
Enable or disable the Calibration Counting function
8.2.1
F1 -
CAL
To advance to the next parameter, press the [0] key or to enter the calibration parameter
press the [Tare] key when “
F1 CAL
” is displayed.
The display will instruct you to remove any weight from the scale, “
UnLoAd
”. Press [Tare] .
The display will tell you to add weight to the scale: “
LoAd
” “
6
” “
kiloS
”
Add the weight shown, wait for stability then press the [Tare] key.
The display will show “
SPAn
” “
PASS
” if the calibration is OK. Or it will show “
SPAn
” “
FAIL
” if
calibration could not be completed correctly.
The display will then show “
JP on
” indicating the jumper is still in place if it was used to
gain access. Remove the weight. Switch off the scale and switch it on to continue with
the other Service parameters.
8.2.2
F2
–100G
To enter this parameter, press the [Tare] key when “
F2 100G
” is shown.
The display will show “
PriCE
“ “
on
” or “
PriCE
“ “
oFF
” .