Page 17 of 48
9.4.2 Percent Weighing
Percent weighing will be done by defining a certain weight to be 100%. The
weight to be used can either be entered by the user or taken from a sample
•
Press
[Mode]
and then the
[Up]
or
[Down]
key to select Percent
weighing, “PERCENT” will be displayed
•
Press
[Enter]
to enter the function
•
Display will show, “PERCENT SAMPLE”
•
Press
[Enter]
to select the sample method or scroll to manually enter
the sample weight as given below
•
When “LOAD 100 %“ is shown, add the sample
•
Press
[Enter]
to set this weight to be 100%. The display will show “REF
WT” and the sample weight in the last selected unit. After a while
“100%” will be displayed. A message “PERCENT” will be prompted on
the top of the display to indicate that the balance is in the percent
weighing mode
•
Remove the sample and “PERCENT 0.00%” will be displayed
•
Place an unknown sample to display the percentage weight
•
To set another weight as 100%, press
[Mode]
and continue as before
•
To manually enter a value to be set as 100%, press
[Up]
or
[Down]
key
when “PERCENT SAMPLE” is shown to select “PERCENT Ent Wt”
•
Press
[Enter]
. Display will show the value in the unit last used in the
weighing mode
•
Enter the weight using the numeric entry method (see section 7.1).
•
Place unknown sample to display the percentage weight
•
To perform percent weighing with another sample press
[Mode]
and
continue as before
•
To return to normal weighing, press
[Esc]
NOTE:
Percentage will be initially displayed to the maximum number of
decimal places based on the resolution of the balance. To increase or
decrease by one decimal place, press the
[Up]
or
[Down]
key respectively.
© Adam Equipment Company 2007