Ada GroundDrill-12, Руководство по эксплуатации

Страница: 7 / 34

Drill - 12
MEASUREMENT FOUNDATION
Ground Drill - 12 Drill - 12
7
AUGER CHECKUP
1. Check parts are not loose nor missing. This goes especially for the spark
plug.
2. Check the air intake and outlet for clogging.
3. The auger uses an air-cooled engine. If the air passage is blocked, the
engine may overheat.
4. Check the air ilter for dirt. A dirty air cleaner will cause the auger to
burn excess fuel.
5. Check the spark plug for spark.
ENGINE OIL
Caution
: Oil is a major factor affecting performance and service life. Use
detergent oil. It’s not recommended to use vegetable-based luid. Check the
engine oil level with the engine stopped and in a level position.
Note
: SAE 10W-30 is recommended for general use.Use oil SAE Synthetic
5W-30 when the average temperature in your area is within the recom
-
mended range.
Check the engine with the engine stopped and in a level position.
1.Remove the oil iller cap/dipstick and wipe it clean.
2. Insert the oil iller cap/dipstick into the oil iller neck as shown, but do not
screw it in, then remove it to check the oil level.
3. If the oil level is near or below the lower limit mark on the dipstick.
Note:
Don’t start engine if the oil level is below the lower limit mark. It
can damage the engine.
30
10W-30
5W-30
dipstick
upper oil level
low oil level