AD Boivin 2002 Snow Hawk, Руководство по обслуживанию

Страница: 60 / 173

ENGINE / CYLINDERS AND CYLINDER HEADS 7 - 10
Reassembling
When reinstalling the needle bearings, make sure there are 31
needles between the expansion socket and the positioning
socket.
o
Grease the stop washers and install them at the ends of
the needles.
o
Insert the needles in the connecting rod using a tappet
21 mm (.836 in) in diameter.
o
Install the piston on the connecting rod so that the arrow
under the letters "AUS" is pointing towards the exhaust
port.
o
Install the piston wrist pin extractor (P/N 529 0210 00),
then turn its handle until the piston pin is in the correct
position in the piston.
o
Remove the piston wrist pin extractor and the expansion
socket.
o
Install the circlips according to the directions given below.
When installing new needle bearings, make sure to insert the
needles and the stop washers. The needles are not held in
place by an expansion socket, but rather by two plastic half-
cages.
o
Use a piston wrist pin extractor (P/N 529 0210 00) to
insert the piston pin. The half-cages should come out of
the piston, if not, use duck-bill pliers to take them out.
o
Install the circlips according to the directions given below.
Expansion
socket
Positioning socket 31 Needles