AD Boivin 2002 Snow Hawk, Руководство по обслуживанию

Страница: 144 / 173

ELECTRICAL SYSTEM 14 - 10
6. Trace a new mark on the flywheel and proceed as
follows:
o
Remove the cover of the engine fan.
o
Hold the flywheel so that the old marks are lined up.
o
Trace a mark on the flywheel so that it is in line with
the arrow of the housing: (see the illustration). Use
this new mark for all future adjustments (dynamic
adjustment).
1) Housing arrow
2) Trace a mark here
3) Keep the alignment of the adjustment
marks previously verified (static
adjustment)
o
Reinstall the recoil starter
o
Verify the ignition adjustment using a
stroboscopic lamp
Verifying the ignition adjustment
Use a stroboscopic lamp (P/N 529 0092 00). To verify the
ignition adjustment, see the illustration and proceed as follows:
l
NOTICE:
The engine must be cold during the adjustment. Avoid having
the engine run at low speed for more than 20 seconds and carry
out the adjustments quickly.
u u
WARNING
Place the tips of the ski against a wall. Lift the rear of the
vehicle so that the track does not touch the ground and
install it on a support.
Make sure that no one goes in front of or behind the
vehicle while the engine is running.
Keep away from the track and do not wear loose-fitting
clothing which could be caught up in the moving parts.
1. Plug the stroboscopic lamp into the spark plug wire and
the connectors into the battery.