4 of 25
BII 48865 (1303)
© 2013 American Honda Motor Co., Inc. – All Rights Reserved.
7.
Remove the driver’s sunvisor:
•
Pivot the right sunvisor downward.
•
Wrap tape around the tip of a flat-tip screwdriver.
•
Locate the slot in the bracket cover, and insert
the flat-tip screwdriver into the slot. Push in and
hold the retaining tab.
•
While holding the retaining tab, push up on the
sunvisor and rotate it toward the door.
NOTE: If the retaining tab did not stay pushed in,
return the sunvisor to its original position and repeat
this step.
QB22902AK
RETAINING
TAB
FLAT-TIP
SCREWDRIVER
TAPE
BRACKET COVER
DRIVER’S
SUNVISOR
Push the
retaining tab.
While pushing in
on the retaining
tab, rotate the
sunvisor toward
the door.
Make sure the
retaining tab
slides into the
bracket cover.
FRONT
•
Remove the driver’s sunvisor (unplug the
vehicle connector).
8.
Remove the driver’s A-pillar trim.
•
Pull away the driver’s door opening seal from the
driver’s A-pillar trim.
•
Pull out on the driver’s A-pillar trim to release
three clips.
QB22903AK
DRIVER’S
SUNVISOR
VEHICLE
CONNECTOR
QB22904AK
Pull the clip.
2 CLIPS
DRIVER’S
A-PILLAR
TRIM
DRIVER’S A-PILLAR
DRIVER’S DOOR
OPENING SEAL
(Pull away.)
