HD Intelligent IP Speed Dome Installation Manual Chinese V1.0
30
5-20
【Exposure Mode】
：
Config the exposure time, can be switched between auto/manual,1/50 to 1/10000S .the
shorter the exposure time, the darker the preview screen.
[Day/Night Mode]: Modify day/night mode manually.
Auto: The camera automatically control color of the preview screen according to the actual ambient
light.
Color: The camera remains color preview screen instead of turning black and white when there is
insufficient ambient light.
Black/white: Camera preview turns black/white when there is sufficient ambient light.
[BLC]: Turn off or turn on the backlight compensation. With BLC on, main scenery of the center can
be seen under bright environment.
[Auto Iris]: Turn off or turn on auto-iris
[Profiles]: automatic, indoor and outdoor.
[Auto Exposure Reference]: Set the camera's exposure, selectable between 0 and100, the larger the
reference value, the brighter the preview screen, whereas darker.
[Day & Night Threshold]: associated with IR_CUT switching modes.
IR_CUT automatic switching mode: automatic day and night mode is the critical point, the threshold
greater the higher the brightness, whereas lower.
IR_CUT IR synchronous switching mode: 10-20 to close the switching threshold stabilizer,21-30
Debounce time 3s ,31-40 Debounce time 4s ,41-50 Debounce time 5s.
[WDR]: Set the WDR closed or open. When WDR is on, adjust the cap under bright background to see
the main scenery clearly.
[AE Sensitivity]: When ambient light dramatically changes, the length of time the camera takes
to adapt to the light changes. The higher the sensitivity, the shorter to adapt.
[AGC]: Set AGC turned off or turned on. Auto adjust the sensitivity of the camera according to
the ambient light changes to change the screen brightness.
[E Slow Shutter]: Set the electronic shutter off, weak, medium and strong to increase the brightness
by accumulation, to prolong the exposure time to enhance the image sensor under low light illumination.
[IR_CUT]: can be set as automatically switch or infrared synchronous switch.
Automatic switch: ICUT switch according to the brightness level of the actual environment
Infrared Salvos: ICUT switch is determined by the state of infrared light.
[Day Noise level] : Eliminate the screen lit when the light is sufficient, the higher the level,
the better the reduction.
[Evening Noise level] : Eliminate the preview screen noise level when there is insufficient light,
the higher the noise level, the better.
【Front-end command】
：Send orders to front-end to adjust camera parameters
[Mirror]: When you enable it, the preview screen flip around 90 °.
