Carrier grade groomerII – installation guide
G.3
Removing a Prosody X Card
•
Turn the PCI riser card assembly upside down.
•
If fitted, remove the H.100 cable linking the Prosody X cards together (“E”).
•
Remove the card retaining screw (“A”).
•
Remove the front retention clip by loosening the blue captive screw (“D”) and
rotating the clip outward (“B”).
•
Slide the Prosody X card away from the PCI riser card assembly as shown.
Figure G-3 Prosody X Card Removal and Installation
G.4
Installing a Prosody X Card
If replacing an Aculab Prosody X card, use the same slot in the PCI riser card
assembly for the replacement card. If adding a new Prosody X card, remove the
blanking plate of the next free slot by removing its retaining screw (“A”).
If not already done, remove the front retention clip (“B”) by loosening the blue captive
screw (“D”) and rotating the clip outwards.
To install the card:
•
Slide the Prosody X card into the PCI riser card assembly as shown in Figure
G-3. Ensure that the Prosody X edge connector is correctly inserted into the
riser card connector (“C”).
•
Secure the Prosody X card to the riser card assembly with the retaining screw
(“A”).
•
Refit the front retention clip (“B”) and tighten the blue captive screw (“D”).
•
If more than one Prosody X card is installed, refit the H.100 cable (“E”). If an
additional Prosody X card has been installed, a new H.100 cable with an extra
connector will be required.
41 of 44
