ActronAir Classic 2 EAA130S, Руководство по установке и пусконаладке

Страница: 19 / 40

Installation and Commissioning Guide
Split Ducted Indoor Units
Installation and Commissioning Guide - Split Ducted Indoor Unit
Doc. No.0525-074 Ver. 3 200811
19
06. Installation Instructions
The installation instructions provided below are intended as a guide only and does not supersede the relevant council,
state and federal codes, regulations and building code standards. Compliance and consultation with the authorities having
jurisdiction with the installation of this equipment is the responsibility of the installer. ActronAir will not be held liable for
any damages or costs as a result of the installer’s failure to comply. Please refer to the matching outdoor unit Installation and
Commissioning Guide for further information and details.
Lifting The Unit
The installation instructions provided, in Section 07, adhere to WH&S regulations for safe and secure lifting practices in order
to prevent physical injury.
Suggested lifting procedures are outlined in Section 07 as a reference guide to safely lift and transport the unit, however,
this does not over rule the industry WH&S practices.
Location
This unit is intended for indoor installation only. It is highly recommended that this indoor unit and accessories, particularly
zone barrels, be mounted in the roof cavity.
Mount the unit in a stable and rigid support wherein the weight is properly distributed, such as roof joist and rafters. Take
into consideration the minimum service access clearances provided in the unit drawings.
Locate the indoor unit away from the areas where noise is a critical factor. Use rubber mounting pad (not supplied) in order
to minimize the transfer of noise and vibration into building structures.
An optional hanging bracket assembly and rubber grommet (supplied as standard with EVA230S) is also available to secure
the indoor unit into the roof rafters. This installation configuration is most suitable for installation that require the unit to be
rigidly secured up from the roof joist.
Condensate and Safety Tray Drainage
An integrated safety drain tray is provided as a standard inclusion to your indoor unit in order to reduce the potential of
condensate damage to the roof. Drain Kit (not included on EVA230S) is provided for the condensate drain to be externally
trapped from the indoor unit. Suggested condensate and safety tray drainage instructions are provided at the proceeding
page for your reference.
Supply Air and Return Air Duct
The indoor unit is supplied with duct flange (except EVA100 ) as standard in order to facilitate the system’s duct connection
into the unit. Supply and return air duct works must be adequately sized to meet the system’s air flow and static pressure
requirements. Refer to the unit drawing for supply air and return air duct dimensions, specific to your requirement.
NOTE
Fit a flexible duct connection in between the unit and the duct system, where noise and vibration is a critical consideration.
Return Air Filter
Air filters must be provided in the return air side of the unit to maintain the efficiency and prolong the operation of the unit.
These are also paramount to satisfy requirement for a clean and hygienic room condition. Return Air filters must be placed in
an easily accessible location for service and maintenance.
NOTES
• Return Air filters are not supplied with the unit as individual air filtration requirements vary.
• Ensure that filters are cleaned / replaced regularly.