Vehicle Diagnostics
4 – 8 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
4 4
Pending Codes
Pending Codes
are also referred to as continuous monitor or maturing
codes. An intermittent fault causes the control module to store a code
in memory. If the fault does not occur within a certain number of
warm-up cycles (depending on vehicle), the code clears from memory.
If fault occurs a specific number of times, the code matures into a DTC
and the MIL illuminates or blinks. This function can be used with KOEO
or KOER
The
Pending Codes
function is used to read any pending codes which
may be currently set.
✓
Pending Codes
may be set by emission related powertrain
components and systems.
✓
Pending Codes
faults
do not
automatically indicate a faulty
component or system.
From the
OBD II Function List
:
1. Select
Pending Codes
•Use
UP
or
DOWN
arrow
key until
Pending Codes
is
highlighted
•Press
ENTER
.
✓
If no
Pending Codes
are present a message stating
System Pass:
No Faults Detected
is displayed. (Do not mistake this message. It
refers
only
to Pending Codes and is not a warning of DTCs.)
2. Select a Vehicle
.
•See
Vehicle Selection
for details regarding this step.
✓
This step is available only if manufacturer’s specific enhanced DTCs
were read from the vehicle and a vehicle has not been selected since
the tool was powered up.
✓
Selecting a vehicle may provide the user with the manufacturer’s
definition for the manufacturer specific DTC(s) returned by the
vehicle.
OBD II Function List
=====================
I/M Readiness
Read Codes
Pending Codes
Erase Codes
State OBD Check
View Data
Содержание AutoScanner Plus CP9180
