Active S.r.l.
Via Delmoncello, 12 – 26037 San Giovanni in Croce (Cr) – ITALY
Tel. +39 0375 91742 Fax +39 0375 91684
www.active-srl.com
46
18.
PROBLEMS AND CAUSES
Unit
Problem
Probable cause
Possible solution (*)
PRUNER
The pruner stops
during the job.
Advice of error (see
display). See the relative
paragraph.
The pruner must be delivered
to an Authorised Reparation
Centre for check.
The pruner doesn’t
work.
The pruner has not been
correctly connected to its
power unit.
Check the correct connection
of the pruner with the power
unit.
The blade of the pruner
is located in a different
point from the closure.
Switch on following the
standard procedure.
The battery is down.
Verify that the batteries are
charged.
The pruner has a low
cutting force or has a
bad cut.
The cutting blade is very
worn or indented.
Always keep the cutting blade
well sharped.
The fix cutting blade is
very worn.
Check and sharpen or change
if it’s necessary.
The pruner will
overheat.
The cutting blade is very
worn or indented.
Always keep the cutting blade
well sharped.
The fix cutting blade is
very worn.
Check and sharpen or change
if it’s necessary.
The battery does not
last long.
The cutting blade is very
worn or indented.
Always keep the cutting blade
well sharped.
The fix cutting blade is
very worn.
Check and sharpen or change
if it’s necessary.
The battery charger
doesn’t work.
Check the state of the battery
charge.
(*):If the problem persists consult your dealer and or the Service Centre nearest you.
