actiLib Autoloader 1U
– User and Service Guide
Page 89 of 97
7.
Place the replacement loader enclosure on a solid surface in preparation for installation in
to the rack.
8.
Remove the mounting brackets and guide pulleys from your loader and install them on the
replacement loader.
9.
Loosen the blue thumbscrews on the tape drive, and pull the tape drive handle while
supporting the bottom of the drive to remove from your loader.
10.
Install your drive in the replacement loader enclosure.
11.
Remove the shipping lock on the rear panel.
12.
Store the lock and label to the top cover (see
13.
Slide the replacement loader enclosure onto the metal rails that are already in position in
the rack.
14.
Tighten the mounting bracket screws to anchor the replacement loader enclosure to the
rack.
15.
Plug in the power cord and host interface cable into the replacement loader enclosure.
16.
Power on the loader.
17.
Run the Loader Verify test (refer to
OCP “Service: Loader Verify”).
18.
Securely package the loader enclosure that was replaced, and return to repair center (see
section 10)
